Manual EVOTOUCH v.5 86 / 104
3) Switch on the electrolysis / dosing System. The CL reading will
increase slowly and it will be stable after some minutes.
Note: When the probe is connected for the first time, the
stabilization time could take longer than usual. In any case, it is
recommendable wait for at least 3 hours before making the first
calibration.
4) Calibration
Wait until the CL reading is stable. If there is a difference between the
display reading and the water DPD-1 tester is observed, start a
calibration as follows:
To Next Page
Loading...