BT BT2600 - Registering Additional Handsets; Process for Registering a Handset

If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
64
You can register up to five GAP
compliant handsets to your
BT2600 base to extend your
phone system without needing
to install telephone extension
sockets for each new phone.
If a handset becomes
un-registered it will need to be
registered to the base again.
Register handset? will be
displayed, press then
follow the instructions starting
from point 4 opposite.
You have 2 minutes to complete
the registration process.
If registration isn’t successful
the first time, please try again
incase the base registration
period ran out of time.
If there are already five
handsets registered to the
base, the registration will fail.
You must de-register another
handset before you can register
the new one, see page 65.
If you’ve bought a BT2600 multiple pack, any
additional handsets come pre-registered to the
base. However, if you purchase an additional
handset separately, you must register it to your
BT2600 base before it can be used.
Register an additional handset
1. Select
Menu , scroll to Settings and press .
2. Press
until Registration is displayed and
press
.
3.
Register Handset is displayed, press .
4.
Press & hold find on base is displayed. Press and
hold the
Find
Answer
On
button on the base for 5 seconds. The
green In use light on the base will start to flash.
5. Immediately, press
on the handset. The handset
will display
Registering handset to indicate the
base is in registration mode. If the system PIN is not
0000 then you will be prompted to enter it, then
press
.
6. Once registration is successful the handset will
show
Handset x registered (with X being the
assigned handset number) and you will hear a
confirmation tone.
Using additional handsets