If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
If you’ve bought a BT8500 multiple pack, any additional handsets come pre-
registered to the base. However, if you purchase another additional handset
separately, you must register it to your BT8500 base before it can be used.
You can register up to five GAP compliant handsets to your BT8500 base.
Register an additional BT8500 handset
1. Select Menu, scroll
to display Settings and press Select.
2. Press
to highlight Registration and press Select.
3. Register is highlighted, press Select.
4. Press and hold Find button on base is displayed.
5. Press and hold
Find
on the base until you hear a beep and the In use light starts
to flash.
6. Immediately, select OK on the handset. The handset will display Registering
handset to indicate the base is in registration mode. If you have changed the
system PIN from 0000 you will be prompted to enter it, then select OK.
7. Once registration is successful the handset will show Handset x registered (with
X being the assigned handset number). The handset will then synchronise data
with any other registered handsets, e.g. contacts, speed dials, handset names
and text messages.
You have 2 minutes to complete the registration process. After 2 minutes the
In use light on the base will stop flashing. If registration isn’t successful the first
time, please try again incase the base registration period ran out of time.
Using additional handsets66
To Next Page
Loading...
