General Settings
[WX Mode]: Use this to select Off, Monitor (to Listen), or Alert
(NOAA Warnings only) After using Monitor, you may need to
adjust the squelch tighter to quiet the receiver- found under
Device Settings- see figure 9 previous page
[WX Channel]: Choose the local NOAA channel
[TX Time Limit]: Set the time limit for device transmit.
[TX Hold Time]: When using a repeater, set the lag time for the
end of transmission.
[PTT Follow]: Once a sub channel becomes active, allows transmission
on the sub channel (within 10 seconds after the channel becomes
active) without needing to switch to the sub channel.
[Tail Elimination]: Automatically eliminate the noise after the
end of transmission.
[Audio Relay]: Record and transmit the received voice
(Recording time is up to 30 seconds).
Please be cautious when using Audio Relay. If two radios are
too close, they will fall into an endless loop of transmitting and
receiving. Please do not turn on this function on a repeater
(REPT) channel.
To Next Page
Loading...
