Buchi SyncorePlus - Installing the Cap Nut (Polyvap and Analyst Configuration Only); Installing the Vapor Sensor (Option)

5 | Installation BÜCHI Labortechnik AG
24/56 Operation Manual SyncorePlus
5.6.5 Installing the cap nut (Polyvap and Analyst configuration only)
u Attach the cap nut with seal onto the con-
denser.
5.6.6 Installing the vapor sensor (Option)
There are two vapor sensors available:
Order no. Image
Vapor temperature sensor. Incl. cap nut, seal
GL14
Measures the vapor temperature inside the sys-
tem. Meant to be used with the Interface I-300 /
I-300 Pro.
11060707
AutoDest sensor. Incl. cap nut, seal GL14
For automatic distillation. Measures temperature
of cooling media and the vapor temperature. Vac-
uum is adjusted according to cooling capacity of
condenser. Meant to be used with the Interface
I-300 / I-300 Pro and glass assembly V, HP or S.
11059225
u Attach the sensor to the condenser.
u Attach the plug onto the VacuBox.