Buchi SyncorePlus - Setting Evaporation Parameters

7 | Operation BÜCHI Labortechnik AG
36/56 Operation Manual SyncorePlus
View Status
Setting mode
Vacubox and Interface are connected
Rotation is locked
See Chapter8.2 "Locking and unlocking the rota-
tion", page40
7.1.3 Setting the evaporation temperature
Offset temperature:
 The cover temperature is automatically adjusted with the heater base temperature.
 The range can be set between 20 - 70 °C
NOTE
After 1 minute without using the control panel the instrument returns to the basic
mode.
u Tap the button SET.
ð The set temperature for heater base flashes.
ð The status panel shows the status OK and Setting.
u Turn the navigation control to the temperature according to the requirements.
u Tap the button SET.
u Turn the navigation control to the offset value according to the requirements.
u Tap the button SET.
ð The offset temperature is changed.
ð The temperature is set.
7.1.4 Setting the cooling water follow-up time
NOTE
After 1 minute without using the control panel the instrument returns to the basic
mode.
The follow-up cooling water time can be set from 0 - 30 min.
u Tap the button SET three times (3x).
u Turn the navigation control to the follow-up time according to the requirements.
u Tap the button SET .
ð The cooling water follow-up time is changed.
7.2 Carrying out an evaporation (with control system)
NOTE
Using the control system. See operation manual "Interface I-300 Pro ".