Additional programming options
8
Logamatic 4121, 4122 and 4126 - Subject to technical modifications.
65
Only after all three details (day/time/temperature) have been set for the new
switching point will it be automatically saved under "Own program" and the
heating circuit number (here: "2"). This saving is not shown on the display. The
display shows the blank screen "New switch.point" for the next switching point.
z Enter the second switching point (Monday – Friday, 21:00 h, 17 °C).
z Enter the third switching point (Saturday – Sunday, 09:30 h, 21 °C).
z Enter the fourth switching point (Saturday – Sunday, 23:30 h, 17 °C).
To enter the second to fourth switching points, you only need to repeat the
steps
described above.
Press "Back" to return to the permanent display only after all switching points
have been correctly entered.
Your heating program will now operate according to your "Own program".
You
can call up your new "Own program" by pressing "Prog" and turning
the
rotary selector.
To Next Page
Loading...
