Buehler IsoMet 5000 - Page 4

Buehler IsoMet 5000

76 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

This page was intentionally left blank.

iv

MA112780_38.6 [Original Instructions] 9/19/2011

Table of Contents

Table of Contents5
Isomet 5000 Linear Precision Saw7
Warranty7
Specifications7
Safety Information8
- Machine Use and Care8
- Safety Terms9
Unpacking9
Installation10
Electrical Installation10
Blade Installation11
- Installing a Blade11
Cooling and Lubrication12
Vises12
External Recirculating System13
Isomet 5000 Controls and Functions14
- Front Panel Controls14
  - Directional Buttons16
Isomet 5000 Display Screens and Commands17
- Parameter Fields17
- L1 Display Screen18
  - L1 Display Screen Commands18
  - Pause CUTTING CYCLE18
- L2 Display Screen19
  - L2 Display Screen Commands19
- L3 Display Screen20
  - L3 Display Screen Commands20
- L4 Display Screen21
  - L4 Display Screen Commands21
Specimen Positioning22
- Hard Home22
- Specimen Loading22
- Positioning a Specimen with an Unknown Thickness (Without the Specimen Positioning System Installed)23
- Positioning a Specimen with a Known Thickness (Without the Specimen Positioning System Installed)1925
- Positioning a Specimen with the Specimen Positioning System Installed26
Operation27
- Cutting a Specimen and Serial Sectioning27
- Single Cut Without the Specimen Positioning System27
- Single Cut with the Specimen Positioning System with the DATUM off Function28
- Single Cut with the Specimen Positioning System with the DATUM on Function29
- Multiple Cuts Using the Specimen Positioning System with the DATUM off Function30
- Multiple Cuts Using the Specimen Positioning System with the DATUM on Function31
- Manual Cutting32
Blade Dressing33
- Dressing the Blade34
SMART CUT: Checking and Adjusting the Feed Rate33
Automatic Blade Dressing, Rotating Chuck, and Specimen Positioning System35
- Removing the Specimen Position System (Catalog Number 11-2699)35
- Installing the Specimen Position System36
- Removing the Rotating Chuck (Catalog Number 11-2695)36
- Installing the Rotating Chuck36
- Removing the Automatic Blade Dressing System (Catalog Number 11-2696)37
- Installing the Automatic Blade Dressing System37
Loading and Saving Methods38
- To Load a Method38
- To Save a Method39
Warning Messages40
Maintenance41
- Internal Coolant/Lubricant Recirculating System41
  - Draining the Coolant41
- Automatic Blade Dressing42
  - Cleaning the Automatic Blade Dressing Shaft42
- Checking the Blade Motor Total Hours42
Trouble Shooting Chart43
Isomet 5000 Precision Saw Application Guide73

Related product manuals

Preview: Buehler ISOMET Low Speed Saw

Buehler ISOMET Low Speed Saw