4-96 2003 Buell XB9S: Fuel System
HOME
REMOVAL
1WARNING1WARNING
To protect against accidental start-up of vehicle, discon-
nect the negative battery cable before proceeding. Inade-
quate safety precautions could result in death or serious
injury.
1. Disconnect negative battery cable.
2. Remove intake cover assembly. See 2.35 INTAKE
COVER ASSEMBLY.
3. Remove airbox. See 4.43 AIRBOX.
4. See Figure 4-72. Disconnect the spark plug cables from
the coil plug posts (1, 5).
5. Detach connector (3) [83].
6. Remove coil fasteners (2).
INSTALLATION
NOTE
To ease installation, install spark plug cables to ignition coil
first.
1. Connect spark plug cables to ignition coil.
2. See Figure 4-72. Attach coil to frame with fasteners (2).
Tighten to 120-144
in
-lbs
(13.6-16.3 Nm).
3. Attach front and rear spark plug cables to ignition coil
posts.
4. Attach connector (3) [83].
5. Install ram air scoop assembly. See 2.36 AIR SCOOPS.
6. Install airbox. See 4.43 AIRBOX.
7. Install intake cover assembly. See 2.35 INTAKE COVER
ASSEMBLY.
8. Connect negative battery cable.
Figure 4-72. Ignition Coil Location
Figure 4-73. Ignition Coil
8843
1
3
2
1. Front cylinder post
2. Fasteners
3. Coil connector [83]
4. Coil
5. Rear cylinder post
5
4
1
1. Rear Cylinder Post
2. Coil Pin A (rear cylinder)
3. Coil Pin B (12 VDC)
4. Coil Pin C (front cylinder)
5. Front Cylinder Post
2 3
4
5
b0993x4x
To Next Page