Buell 2003XB9S - 7.25 Sprocket Cover Wiring

2003 Buell XB9S: Electrical 7-71
HOME
SPROCKET COVER WIRING 7.25
GENERAL
Connectors for the stator [46], voltage regulator [77], vehicle
speed sensor [65], cam position sensor [14] and neutral
switch [131] are located under the sprocket cover.
REMOVAL
1. Remove sprocket cover. See 2.31 SPROCKET COVER.
2. See Figure 7-85. Disconnect appropriate connector(s).
INSTALLATION
NOTE
See Figure 7-85. All wiring under sprocket cover that gets
routed from sprocket area towards front of vehicle is routed
behind cam cover breather hose (8).
1. Route oil pressure switch wiring (10) from main harness
(6), behind cam cover vent hose (8) to oil pressure switch
located on front of engine.
2. Route sidestand switch wiring (not shown) from main
harness, underneath engine and to sidestand switch
[133].
NOTE
Stator connector wiring is installed over oil pressure and side-
stand switch wiring.
3. Connect stator connector (9).
4. See Figure 7-86. Connect cam position sensor [14] (1).
Form a loop (2) as shown using wiring leading to cam
position sensor.
Figure 7-85. Sprocket Cover Wiring
Figure 7-86. Cam Position Sensor Wiring
8748b
1. Voltage regulator connector [77]
2. Cam position sensor connector [14]
3. Neutral switch connector [131]
(approximate location)
4. Neutral switch location
5. Cable strap
6. Main harness
7. Vehicle speed sensor connector [65]
8. Cam cover vent hose
9. Stator connector [46]
10. Oil pressure switch wiring
4
7
9
3
2
1
8
10
6
5
5
5
8745
1. Cam position sensor [14]
2. Cam position sensor and neutral indicator
switch wiring
3. Neutral switch location
4. Cam cover breather hose
5. Stator connector [46]
6. Oil pressure switch wiring
1
6
4
3
2
5