5-12 2003 Buell XB9S: Starter
HOME
STARTER 5.7
REMOVAL
1. Remove seat. See 2.41 SEAT.
1WARNING1WARNING
Always disconnect the negative battery cable first. If the
positive cable should contact ground with the negative
cable installed, the resulting sparks may cause a battery
explosion which could result in death or serious injury.
2. Disconnect battery. See 1.5 BATTERY MAINTENANCE.
3. Remove primary cover. See PRIMARY COVER under
6.2 PRIMARY CHAIN.
4. Remove sprocket cover. See 2.31 SPROCKET COVER.
NOTE
A ball hex driver may be required to gain access to the starter
mounting bolts.
5. See Figure 5-8. Remove two starter mounting bolts and
washers (1).
6. See Figure 5-9. Remove fastener with washer (1) (met-
ric).
a. Remove protective boot.
b. Remove positive battery cable ring terminal (2).
c. Detach solenoid wire (3).
7. Remove starter and gasket from the gearcase cover side.
Figure 5-8. Starter Mounting
Figure 5-9. Starter Wires (Protective Boot Not Shown)
1
1
2
1. Mounting bolts and washers
2. Starter
b0312x5x
8742
1. Fastener with washer (metric)
2. Positive battery cable ring terminal
3. Solenoid wire
3
1
2
To Next Page