Buell 2003XB9S - 7.18 Instrument Module

7-52 2003 Buell XB9S: Electrical
HOME
INSTRUMENT MODULE 7.18
GENERAL
Replace the instrument module if the unit is not working prop-
erly or if a lamp is inoperative. The module is not repairable.
However, before replacing a component, check that the prob-
lem is not caused by a loose wire connection.
REMOVAL
1WARNING1WARNING
To protect against shock and accidental start-up of vehi-
cle, disconnect the negative battery cable before pro-
ceeding. Inadequate safety precautions could result in
death or serious injury.
1. Remove seat. See 2.41 SEAT.
2. Disconnect negative battery cable.
3. Remove windscreen. See 2.40 FRONT WINDSCREEN.
4. See Figure 7-63. Disconnect instrument module connec-
tor [39].
5. See Figure 7-64. Remove fasteners (5) and washers (4).
6. Pull instrument module (2) from front support module (1).
INSTALLATION
1. See Figure 7-64. Place instrument module (2) into posi-
tion in front support module (1).
2. Install washers (4) and fasteners (5). Tighten fasteners to
12-36 in-lbs (1.4-4.1 Nm).
3. See Figure 7-63. Connect instrument module connector
[39].
4. Install windscreen. See 2.40 FRONT WINDSCREEN.
5. Install negative battery cable.
1WARNING1WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
6. Install seat. See 2.41 SEAT.
Figure 7-62. Instrument Module
9952
Figure 7-63. Instrument Module Connector [39]
Figure 7-64. Instrument Module
8909
b11130x7x
2
1
6
3
4
5
1. Front support module, left and right
2. Instrument module
3. Grommet (3)
4. Washer (3)
5. Fastener (3)
6. Instrument module connector [39]
1