Buffalo Tech TeraStation - Page 9

8
Adding a drive to an existing RAID array or adding a drive and changing the RAID mode:
Note: After the RAID array is changed (except when creating a RAID 0 array), the TeraStation will perform a RAID
check that will take about 10 hours per TB. File transfers will be slower during this period. While the “RAID
I17 ARRAYx Resyncing” message is displayed on the LCD panel, do not turn o the TeraStation. If you turn
it o, the RAID check will start over.
4 Enter the conrmation number and click Apply.
5 Follow the instructions displayed on the screen.
You have now completed the procedure for changing the RAID mode with RMM.
1 Select the drive to be added to the RAID array.
2 After adding the drive, click your desired RAID mode for the RAID array.