120
3 Uncheck "Use DHCP", enter the IP address and subnet mask, and click OK. If the username and password
prompts appears, enter the admin username and password.
Note: The following IP addresses are reserved and should not be used. If you configure one of them by accident,
initialize settings with the function button on the LinkStation.
Local loopback address: 127.0.0.1, 255.255.255.0
Network address: 0.0.0.0, 255.255.255.0
Broadcast address: 255.255.255.255, 255.255.255.0
The IP address range from 224.0.0.0 to 255.255.255.255
NAS Navigator2 for macOS
NAS Navigator2 is a utility that makes it easy to display Settings, change the LinkStation's IP address, or check its
hard drive. If you installed the LinkStation with LinkNavigator, NAS Navigator2 was installed automatically.
Click the icon in the Dock to start NAS Navigator2.
To Next Page
Loading...
