Arming with the Power Lock Switch
Your alarm system will arm when you use either power
door lock switch to lock the doors while any door or
the liftgate is open and the key is removed from
the ignition. The security light will start flashing to let
you know the system is armed.
Arming with the Remote Keyless Entry
Transmitter
Your alarm system will arm after a
30
second delay
when you press LOCK on your remote keyless
entry transmitter to lock the doors. The security light will
come on for
30
seconds and then start flashing to let
you know the system is armed.
Disarming with Your Key
Your alarm system will disarm when you
use
to unlock the-front doors. The security light w
your key
ill
stop
flashing to let you know the system
is no longer armed.
Disarming with the Remote Keyless
Entry Transmitter
Your alarm system will disarm when you press UNLOCK
on your remote keyless entry transmitter to unlock the
doors. The security light will stop flashing to let you know
the system in no longer armed.
PASS-Key@
111
Your PASS-Key@
Ill
system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada.
This device complies with Part
15
of the FCC Rules.
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with RSS-210
of
Industry Canada.
Operation is subject to the following two conditions:
(1)
this device may not cause interference, and
(2)
this
device
must
accept
any
Interhence receivedj
including
interference that may cause undesired operation of the
device.
Changes or modifications to this system by other than
an authorized service facility could void authorization to
use this equipment.
P,A.ss-!+~@
!!!
2
r?-din
frpq~~pny
trg-nspnnder
in
the key that matches a decoder in your vehicle.
2-1
7
To Next Page
Loading...
Need help?
General
