Headlamp
Exit
Delay
This feature allows you to customize the headlamps and
parking lamps.
Programmable
Modes
Mode
1:
Off (The headlamps and parking lamps will
turn
off
at the same time that the ignition is turned
to OFF.)
Mode
2:
15-Second Activation (The headlamps and
parking lamps will stay on for 15 seconds when
the ignition is turned to OFF.)
Mode
3:
30-Second Activation (The headlamps and
parking lamps will stay on for
30
seconds when
the ignition is turned to OFF.)
Mode
4:
60-Second Activation (The headlamps and
parking lamps will stay on for 60 seconds when
the ignition is turned to OFF.)
Rpf~p
y~Ir
\phi~Ir?
was
shipped
from
the factory. it was
programmed in Mode
3. The mode
to
which the
vehicle has been programmed may have been changed
since it left the factory. To determine the mode to
which your vehicle is programmed or to program your
vehicle to a different mode, do the following:
1.
Follow the instructions for
Entering Programming
Mode
on
page
2-50
2.
Turn the exterior lamp control from the off position
to
the parking lamp position.
3.
Count the number of chimes you hear. The number
of chimes indicates the vehicle’s current
programmed mode.
If
you do not wish to change
the current mode, you can either exit the
programming mode by following the instructions
later in this section or program the next feature
available on your vehicle.
4. Turn the exterior lamp control from the
off
position
to the parking lamp position to change the
current mode.
5. Turn the exterior lamp control from the
off position
to the parking lamp position until you hear the
number of chimes corresponding to the mode
selection you want.
The mode you selected is now set. You can either exit
programming mode by following the instructions
later in thls section or program tne nexi ieature avaiiauie
on your vehicle.
2-5
1
To Next Page
Loading...
Need help?
General
