Canadian Owners:
If
you lose or damage your keys,
only a
GM
dealer can service PASS-Key@
Ill
to
have new keys made. To program additional keys you
will need two current driver’s keys (black in color).
You must add a step to the following procedure. After
Step 3 repeat Steps
1
through 3 with the second current
driver’s key. Then continue with Step
4.
To program the new PK3 key do the following:
1.
Verify the new key has PK3 stamped on it.
2.
Insert the original key in the ignition and start the
engine.
If
the engine will not start, see your dealer
for service.
3. After the engine has started, turn the key to
OFF,
4. Insert the key to be programmed and turn it to
ON
within
10
seconds of removing the previous key.
LA,
aqd
u
I
rnmnwo
VI
I
IV
I
V
tho
.I
..a
.\.a
kny.
5.
The SECURITY message will turn
off
once the key
has been programmed. It may not be apparent that
the SECURITY message went on due to how
quickly the key
is
programmed.
6.
Repeat Steps
1
through
4
if additional keys are to
be programmed.
If you are ever driving and the SECURITY message
comes on and stays on, you will be able to restart your
engine if you turn it
off. Your PASS-Key@
Ill
system,
however, is not working properly and must be serviced
by your dealer. Your vehicle is not protected by the
PASS-Key@
Ill
system at this time.
If
you lose or damage a PASS-Key@
Ill
key, see your
dealer who can service PASS-Key@
Ill
to have a
new key made.
2-1
9
To Next Page
Loading...
