Turn and Lane-Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to
signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.
An arrow on the instrument
panel cluster and the HUD
display will flash
in
the
direction of the turn or lane
change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by itself
when you release it.
As
you signal a turn or a lane change,
if
the arrow
flashes faster than normal, a signal bulb may be burned
out and other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you signal
a turn, check for burned-out bulbs and check the
fuse. See
Fuses
and
Circuit Breakers
on
page
5-96.
If
you have a trailer towing option with added wiring for
the trailer lamps, the signal indicator will flash at a
normal rate even
if
a turn signal bulb is burned
out. Check the front and rear turn signal lamps regularly
to make sure they are working.
Turn
Signal
On
Chime
If
either turn signal is left on for more than
3/4 mile
(1.2
km), a chime will sound to let the driver
know to turn it
off.
If
you need to leave the signal on for more than
3/4
mile
(1.2
km), turn off the signal and then turn it
back on.
Headlamp High/Low-Beam Changer
To
change the headlamps from low to high, simply push
the turn signal lever away from you. Then release it.
To
change the headlamps from high to low, pull the lever
toward you.
1-
When the high beams are
on, this light, on the
instrument panel cluster
and the
HUD
display,
will also be on.
3-8
To Next Page
Loading...
Need help?
General
