Manual
Compass
Calibration
If
the compass appears erratic and the calibration
symbol does not appear, you must manually put the
compass into the calibration mode. To get into this
mode, do the following:
1.
Turn the ignition on and cycle the DIC to the
2.
Press and hold the SET button for longer than
compass/temperature mode.
three seconds.
ZONE
#
PRESS
&
HOLD
SET TO CHANGE:
This
display mode will be displayed when you are manually
calibrating the system. The current zone number for
compass variance will be displayed in place of the
#
symbol. Use the SET button to select the zone number
from the graphic shown
to
select the current area of
the country that you are driving in.
PRESS SET
TO
CALIBRATE COMPASS:
After
selecting your zone, press the MODE button and this
will be displayed on the DIC. Press the SET button and
complete three
360
degree turns in an area free from
large metal objects.
The following two messages
will
toggle in the display
until
you
calibrate the compass:
DRIVE VEHICLE
IN
CIRCLE
CALIBRATING COMPASS
When calibration is complete, the display will return to
its normal mode.
3-57
To Next Page
Loading...
Need help?
General
