EasyManua.ls Logo

Buick 2003 Rendezvous - Page 214

Buick 2003 Rendezvous
468 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Auto
Door
LocMUnlock
The doors will automatically lock when the vehicle
is
shifted out of PARK (P). For automatic unlocking,
you can program your vehicle to one of the following
modes:
OFF:
When the shift lever is put in PARK (P), your
doors will not unlock automatically.
DRIVER:
When the shift lever is put in PARK (P), only
your driver’s door will unlock.
ALL:
When the shift lever is put in PARK (P), all doors
will unlock.
Before
your
vehicle
vms
shipped
from
the facto?;,
it
was
programmed in ALL. The mode to which the vehicle
has been programmed may have been changed since it
left the factory. To determine the mode to which your
vehicle is programmed or to program your vehicle
to a different mode, do the following:
1.
Follow the instructions for “Entering Programming
Mode” listed previously.
2.
Make sure that the AUTO DOOR LOCK feature is
3.
Press the
MODE
button until AUTO DOOR
programmed to ON.
UNLOCK appears
on
the DIC.
4. Press the SET button until the arrow is before OFF,
DRIVER or ALL.
If
the auto door unlock feature has been programmed to
DRIVER or ALL, the automatic door unlock feature
can also be programmed to one of the following modes:
PARK:
Unlock when the shift lever
is
put in PARK (P).
KEY
OUT:
Unlock when the ignition key is removed.
Before your vehicle was shipped from the factory, it was
programmed in PARK. The mode to which the vehicle
has been programmed may have been changed since
it
left the factory. To determine the mode to which your
vehicle is programmed
or
to program your vehicle
to a different mode, do the following:
1.
Follow the instructions for “Entering Programming
Mode” listed previously.
2.
Follow the instructions for programming AUTO
DOOR UNLOCK to DRIVER or ALL listed
previously.
3.
Press the MODE button until AUTO DOOR
UNLOCWPARK KEYOUT appears on the DIC.
4.
Press
the
SFT
button
until
the arrow is before
PARK or KEY OUT.
The mode you selected is now set. You can either exit
programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
3-63

Table of Contents

Related product manuals