Playing
the
Radio
PWR
(Power):
Push this knob to turn the system on
and
off.
VOL (Volume):
Turn this knob to increase or to
decrease the volume.
DlSP (Display):
Press this button to switch the display
between the radio station frequency and the time.
The time can be displayed with the ignition on or
off.
SCV (Speed-Compensated Volume):
With SCV, your
audio system adjusts automatically to make up for
road and wind noise as you drive.
To
get to SCV, press
the TUNE/AUDIO button repeatedly until SPEED
VOL is displayed. Turn the TUNE/AUDlO button to
select OFF, MIN, MED or MAX. Each higher choice
allows for more volume compensation at faster vehicle
speeds. Then, as you drive, SCV automatically
increases the volume, as necessary, to overcome noise
at any speed. The volume level should always sound
the same to you as you drive.
If
you don’t want to
use SCV, select OFF.
Finding
a
Station
BAND:
Press this button
to
switch between AM, FMI,
FM2. The display will show your selection.
TUNE:
Turn this knob to choose a radio station.
la
SEEK
Dl
:
Press the right or the left arrow to go to
the next or to the previous station and stay there.
To scan stations, press and hold one of the SEEK
arrows for two seconds until SCAN appears on
the display. The radio will
go
to a station, play for a few
seconds, then go on to the next station. Press one of
the SEEK arrows again to stop scanning.
To scan preset stations, press and hold one of the
SEEK arrows for more than four seconds until PSCAN
and the preset number appear on the display. You
will hear a double beep. The radio will go to the first
preset station stored on your pushbuttons, play for a few
seconds, then go on to the next preset station. Press
one of the SEEK arrows again
to stop scanning presets.
The radio will seek and scan only to stations that are
in the selected band and only to those with a strong
signal.
3-70
To Next Page
Loading...
Need help?
General
