DlSP
(Display):
Press this button to switch the display
between the radio station frequency and the time.
Time display
is available with the ignition turned
off.
For XMTM (USA only,
if
your radio
is
equipped with XMTM
Satellite Radio Service), pressing this button while in
XMTM
mode to retrieve various pieces of information
related to the current song or channel. By pressing and
releasing the RCL button, you may retrieve four
different categories
of
information: Artist, Song Title,
Category or PTY, Channel Number/Channel Name.
For DAB (Canada only,
if
your radio is equipped with
DAB), pushing this knob switches the display between
channel name and PTY name.
To change the default on the display, push this button
until you see the display you want, then hold the
knob until the display flashes. The selected display will
now be the default.
Finding
a
Station
BAND:
Press this button to switch between AM, FM,
FM2,
or XM1, XM2 (USA only,
if
your radio is equipped
with XMTM Satellite Radio Service) or DAB1
,
DAB2
(Canada only,
if
your radio is equipped with DAB). The
display will show your selection.
TUNE:
Turn this knob to choose a radio station.
For DAB (Canada only,
if
your radio is equipped with
DAB), the TUNE knob allows you to navigate the DAB
frequency range. Turning this knob will tune up or tune
down the range. The radio will display the letter
L
with a
number next to it
(1
through 23). Each
L
number refers to
a frequency and there can be multiple stations contained
in one frequency. It may also take
a
few seconds, once
you have tuned to a frequency, for that frequency to
gather all of the stations. Depending on how many
stations are within a frequency, with every tune up or
down, you may be tuning to another station or to another
frequency. The display will show your selections.
la
SEEK
Dl
:
Press the right or the left arrow to go
to
the next or to the previous station and stay there.
To
scan stations, press and hold one of the SEEK
arrows for two seconds until SCAN appears on
the display. The radio
will
go to a station, play for a few
seconds, then go on to the next station. Press one
of
the SEEK arrows again to stop scanning.
To scan preset stations, press and hold one of the
SEEK arrows for more than four seconds until PSCAN
and the preset number appear on the display. You
will hear a double beep. The radio
will
go to the first
preset station stored
on
your pushbuttons, play for a few
seconds, then go on to the next preset station. Press
one of the
SEEK
arrows again to stop scanning presets.
The radio will seek and scan only to the stations that
are in the selected band and only to those with a strong
signal.
3-78
To Next Page
Loading...
Need help?
General
