To fold the seatback down,
pull up on the lever located
on the back of the seat.
Push down on the
seatback until
it
is locked
into place.
Push and pull on the seatback to make sure that it is
locked into place.
To raise the seatback,
do
one
of
the following:
From the rear of the vehicle, pull up on the lever to
release the seatback. Then pull the strap, located
on the right side of the seat, to pull the seatback up.
the side of the seatback when not in use, or
~
TI.
-
I
r
le
seaib~k i?&s
2
p~~ket
:G
SO;;{
tk
s:;~li;
X
0
from the passenger’s side door, pull up on the lever
to
release the seatback. Then push up on the
seatback to raise the seat.
Push and pull on the seatback to make sure that it is
locked into the upright position.
Removing the Stowable Seat
I.
Remove the convenience center,
if
it is in the
vehicle. See
Rear Convenience Center
on
page
2-46
for more information.
2.
Make sure all items are
off
of the stowable seat.
3.
If
the seatback
is
down, put the seatback in
its upright position before removing the seat.
See “Folding the Seatback” listed previously.
4.
From the front of the bench seat, remove the two
nuts from the brackets, located on the floor on
each side.
seatback down.
5.
From behind the bench seat, fold the
6.
Remove the rear nuts located on the floor on
each side.
7.
Remove the seat by rocking
it
slightly toward the
rear of the vehicle and then pulling it out through
the rear
of the vehicle. This should be done in one
motion.
8. Put the nuts back onto the screws
so
the nuts do
not get misplaced.
1-15
To Next Page
Loading...
Need help?
General
