Notice:
If
the other system isn’t a 12-volt system
with a negative ground, both vehicles can be
damaged.
2.
Get the vehicles close enough so the jumper cables
can reach, but be sure the vehicles aren’t touching
each other. If they are, it could cause a ground
connection you don’t want. You wouldn’t be able to
start your vehicle, and the bad grounding could
damage the electrical systems.
To
avoid the possibility
of
the vehicles rolling, set
the parking brake firmly on both vehicles involved in
the jump starting procedure. Put an automatic
transaxle in PARK (P) or a manual transaxle
in NEUTRAL before setting the parking brake.
Notice:
If you leave your radio on, it could be badly
damaged. The repairs wouldn’t be covered by
your warranty.
3.
Turn off the ignition on both vehicles. Unplug
unnecessary accessories plugged into the cigarette
lighter or in the accessory power outlet(s). Turn
off
the radios and all lamps that aren’t needed. This
will avoid sparks and help save both batteries.
And it could save your radio!
4.
Open the hoods and locate the batteries. Find the
positive
(+)
and negative
(-)
terminals on each
vehicle.
You will not need to access your battery for jump
starting. Your vehicle has a remote positive
(+)
jump starting terminal for that purpose. The terminal
is located under a tethered cap at the front of the
underhood fuse and relay center. See
Engine
Compartment Overview on page
5-12
for more
information on location.
Flip the cap up to access the remote positive
(+)
terminal. You should always use the remote
positive
(+)
terminal instead
of
the positive
(+)
minal on the battery.
An electric fan can start up even when
!
engine is not running and can injure you. Keep
hands, clothing and
tools
away from any
underhood electric fan.
I
5-42
To Next Page
Loading...
Need help?
General
