Ignition Transaxle Lock Check
While parked, and with the parking brake set, try to turn
the ignition key to OFF in each shift lever position.
The key should turn to OFF only when the shift lever
The key should come out only in OFF.
is in PARK (P).
Parking Brake and Automatic Transaxle
Park
(P)
Mechanism Check
W-.-n
you are c.-.ng this che
.
-.,
you1
~
ehicle
could begin to move. You or others could be
injured and property could be damaged. Make
sure there
is
room in front of your vehicle in
case
it
begins to roll. Be ready
to
apply the
regular brake at once should the vehicle begin
to
move.
Park on a fairly steep hill, with the vehicle facing
downhill. Keeping your foot on the regular brake, set the
parking brake.
To check the parking brake’s holding ability: With
the engine running and transaxle in NEUTRAL
(N), slowly remove foot pressure from the regular
brake pedal.
Do
this until the vehicle is held by the
parking brake only.
To
check the PARK
(P)
mechanism’s holding
ability: With the engine running, shift to PARK (P).
Then release the parking brake followed by the
regular brake.
-
Underbody Flushing Service
At least every spring, use plain water to flush any
corrosive materials from the underbody. Take care to
clean thoroughly any areas where mud and other debris
can collect.
6-1
2
To Next Page
Loading...
Need help?
General
