Bulteh 2000 SMART EBULLIOMETER - Description of Error Group 4: File Management Related Errors; Description of Error Group 5: Real Time Clock Related Errors; Description of Error Group 6: Power Block and Power Management Related Errors

6
Temperature sensor calibration need restoring
7
Wrong defined time period
8
Damaged measurements counter
9
Measurements counter check-sum error
10
No pressure sensor found
6.5. Description of error group 4: File management related errors
Code
Description
1
The operation is aborted
2
File check-sum error
3
Firmware update file version error
4
Incompatible device type stored in firmware update file ( SUF file)
5
Incompatible firmware type stored in firmware update file ( SUF file)
6
Incompatible encoding in firmware update file (SUF file)
7
Section checksum error in firmware update file (SUF file)
8
Incompatible file
9
No suitable firmware update file found (SUF file)
10
Go to back
11
Go to home
12
Incomplete file
13
No enough data
14
No USB flash memory connected
15
Header-part file check-sum error
16
Data-part file check-sum error
17
The data in the file are obsolete
18
Too deep recursion during the folder copy
19
File version error
6.6. Description of error group 5: Real time clock related errors
Code
Description
1
I2C protocol - No start
2
I2C protocol - No acknowledge
3
Wrong date
4
Тhe clock does not work
6.7. Description of error group 6: Power block and power management related errors
Code
Description
1
Heater power value is out of range
2
Error in heater over current comparator
3
Heater over current, registered from the comparator
4
Power voltage 24V in active state and relay turned on is over maximum value
5
Power voltage 24V in active state and relay turned on is under minimum value
6
Power voltage 24V in passive state and relay turned on is over maximum value
7
Power voltage 24V in passive state and relay turned on is under minimum value
8
Reference voltage used for heater current measurement is over maximum value
9
Reference voltage used for heater current measurement is under minimum value
10
No determined reference voltage used for heater current measurement is
11
Measured heater current in active state and relay turned on is over maximum value
12
Measured heater current in active state and relay turned on is under minimum value
13
Measured heater current in passive state and relay turned on is over maximum value
14
Measured heater current in passive state and relay turned on is under minimum value
15
Measured heater voltage in active state and relay turned on is over maximum value
16
Measured heater voltage in active state and relay turned on is under minimum value
17
Measured heater voltage in active state and relay turned off is over maximum value