Bulteh 2000 SMART EBULLIOMETER - Description of Error Group 7: EEPROM Related Errors; Description of Error Group 8: System Timers Related Errors; Description of Error Group 9: Atmospheric Pressure Sensor Related Errors

18
Measured heater voltage in active state and relay turned off is under minimum value
19
Measured heater voltage in passive state is over maximum value
20
Measured heater voltage in passive state is under minimum value
21
Error in heater current measurement test
22
Dangerous high temperature of the power block.
23
Heater temperature is over maximum value
24
Heater temperature in the start of the measurement is over maximum value
25
Heater temperature is under minimum value
26
The time while the heater is powered with high power is too long
27
Heater temperature while the heater is powered with low power is over maximum value
28
Heater current is over maximum value
29
Power block temperature under minimum specified value
30
Power block temperature over maximum specified value
6.8. Description of error group 7 : EEPROM related errors
Code
Description
1
EEPROM initialization error
6.9. Description of error group 8: System timers related errors
Code
Description
1
Wrong event handler
2
Timer ID is out of range
6.10. Description of error group 9: Atmospheric pressure sensor related errors
Code
Description
1
Wrong ID
2
Wrong structure
3
Device not found
4
Invalid length
5
Communication error
6
Invalid mode
7
Bond wire error
8
Implausible temperature
9
Implausible pressure
10
Calibration parameter is out of range
11
Uncompensated temperature is out of range
12
Uncompensated pressure is out of range
13
Uncompensated temperature and pressure are out of range
14
Uncompensated data cannot be calculated
15
Error in the 32-bit temperature representation
16
Error in the 32-bit pressure representation
17
Error in the 64-bit pressure representation
18
Temperature representation error in double-precision format
19
Pressure representation error in double-precision format
20
Conversion time is out of the limit
21
Pressure value is under minimum value
22
Pressure value is over maximum value
23
Temperature value is under minimum value
24
Temperature value is over maximum value
25
The pressure change value is over the maximum value
26
The temperature change value is over the maximum value
27
Calibration value checksum error
28
Calibration value is out of range
29
Invalid ODR/OSR settings