Bulteh 2000 SMART EBULLIOMETER - Description of Error Group 10: Temperature Sensor Related Errors; Description of Error Group 11: Cooling Fan Related Errors; Description of Error Group 12: Boiling Temperature Determination Algorithm Related Errors; Description of Error Group 13: Printer Errors

30
Command execution failed
31
Configuration error
32
FIFO WATERMARK not reached
33
Unknown error
34
Sensor is nor enabled
35
Invalid FIFO REQ FRAME CNT
6.11. Description of error group 10: Temperature sensor related errors
Code
Description
1
I2C protocol - No start
2
I2C protocol - No acknowledge
3
The readiness time of the result is out of the time limit
4
The EEPROM write time is out of the time limit
5
EEPROM write error
6
EEPROM data size error
7
Wrong EEPROM data
8
EEPROM data need to be restored
9
Calibration data check-sum error
10
Calibration value is out of range
11
Offset value error
12
Calibration - Input temperature is too high
13
Calibration - Unstable results
6.12. Description of error group 11: Cooling fan related errors
Code
Description
1
Speed measurement error
6.13. Description of error group 12: Boiling temperature determination algorithm related errors
Code
Description
1
Unstable temperature
2
Distilled water boiling temperature deviation is out of range
3
Distilled water boiling temperature is under the minimum value
4
Distilled water boiling temperature is over the maximum value
6.14. Description of error group 13: Printer errors
Code
Description
1
Printer timeout
2
Start bit error
3
Stop bit error
4
Paper out
5
Overheat
6
Unknown error
7
Cover is open
8
No heat
9
Voltage error
10
Printer is not available