Bunn-O-Matic Corporation
7
Setup and Programming
As with all BUNN
®
digital brewers the equipment has been designed for ease of use for both the end user as well as
service technicians alike. End users have an opportunity to see the status of the equipment during idle time or during
a brew cycle. It is technician friendly, as with any LCD display equipment BUNN
®
manufactures, allowing for step by
step calibrations, diagnostic functions as well as quick adjustments to name a few. The AXIOM™ has gone one step
beyond,byprovidingcuttingedgetechnologybymonitoringoutowratesofwaterexitingthebrewtankthereforeal-
lowing the control board the opportunity to adjust pot levels by increasing or decreasing the brew time needed during
a brew cycle. Resulting in perfect pot levels every time.
User Interface (Programming)
Display: The display shows the various functions.
Right Hidden Button: This is used to access the program mode and is also used to step forward through the menu.
Left Hidden Button: This is used to step backwards through the function list.
Digital (lower left under the display): This is used to select options that appear on the display during programming.
Brewer (center under the display): This is used to select options that appear on the display during programming.
Control (lower right under the display): This is used to select options that appear on the display during programming.
Programming Lockout
If the programming cannot be accessed, then the programming lockout switch is in the
Disable position. The switch is located on the control board. Remove the top panel,
locate the switch and place it into the Enable position.
REAR
FRONT
WARMERS
BUNN
®
WARMER
™
Control
LCD Display
Right Hidden Button
Left Hidden Button
Digital
Brewer
To Next Page
Loading...
Need help?
General
