Bunn-O-Matic Corporation
9
Adjust the target temp of the Brew tank. Range of 185°F to 205°F.
This function sets the minimum temperature to start a brew cycle (BREW LOCKOUT).
Range of 2°F min. to 20°F max. below the Set Temp.
This display allows an optional asset number or tracking number to be assigned.
This function allows the sprayhead to “pulse on and off” during the brew cycle.
This function will adjust the amount of time the display will read “Dripping” after a brew
cycle is completed.
This display allows for a cleaning alert to be displayed (range of 1 to 30 days).
This function allows the tank heater(s) to run at a reduced rate during idle time.
This function allows a “Freshness Alert” message to display when a pre determined time
has elapsed from the last brew. Range 0.5 – 4.0 hrs.
This function allow for auto warmer turn off after a pre determined time has been
entered. Range 15 mins. To 6.0 hours.
Thisfunctionadjustssensitivityoftherellcircuit.
This function allows the brewer to be calibrated in high lime locations and compensate
automatically as deposits build up in the equipment.
Thisisusedtotelltheinternalcontrollerhowfastthewaterisowing.
This function provides a 60 second test mode to capture water from the sprayhead. This
measurement will then give you the numbers to enter into the “SPRAY OZ/M: xx” screen
above. Will not display when BrewLOGIC
®
is enabled.
Tracks the total number of brew cycles completed.
SET TEMP 200
O
(-) (+)DONE
SET READY 195
O
(-) (+)DONE
ENTER ASSET # ?
NO YES
SET PULSE BREW ?
NO YES
DRIP TIME 0:30
(-) (+)DONE
ENABLE CLEAN
NO YESDONE
Enabl Energy Savr
NO YESDONE
Enable Fresh Timer
NO YESDONE
ENABL WARMER OFF
NO YESDONE
XXX REFILL 155
(-) (+)DONE
ENABLE BrewLOGIC
NO YESDONE
SPRAY OZ/M: 25.0
(-) (+)DONE
CALIBRATE FLOW ?
NO YES
BREW COUNTERS ?
NO YES
To Next Page
Loading...
Need help?
General
