burroughs smartsource series - Page 68

Solving Problems
5-10 4326 9562-007
Feeder (continued)
Symptom
Possible Cause
Solution
Symptom
Possible Cause
Solution
Automatic feeder flag does
not close. (Professional units
with automatic feeder flag.)
(cont.)
Dirty feeder sensor.
Blow air with Micro-duster through
the paper path – where feeder bay
touches unit.
Defective feeder sensor.
Return unit for service.
Broken belt.
Return unit for service.
Automatic feeder flag does
not open. (Professional units
with automatic feeder flag.)
Software/hardware
synchronization.
Close the application. Turn the unit
off and then on. Restart the
application.
Application; application settings.
Ensure that the application is
capable of (and settings are correct
for) automatic feeder flag.
Dirty feeder sensor.
Blow air with Micro-duster through
the paper path – where feeder bay
touches unit.
Defective feeder sensor.
Return unit for service.
Broken belt.
Return unit for service.