Product manual 2CKA001473B8291
8.5 Setting the starting / switching times
8.5.1 General
■
STANDBY times can only be set to a point of time that is later than the set comfort time.
■
Night mode cannot be set after 23:59 h, since the starting time (night) will jump to the
comfort time programmed on the same day.
■
BLOCK programming
– So that the switching times need not be entered again for each individual day, the
BLOCK programming function is available. This means that the switching times are
entered once for block (Mon - Fri) and once more for block (Sat - Sun).
■
DAY programming
– Here the switching times for each day can be set independent from each other.
The settings that are available and how the individual menu items are called up is described in
the following sub-sections.
To Next Page
Loading...
