Bush LED24265DVDCNTD - Configuring Network Settings

For any help concerning set up and use of your TV please call the Customer Helpline: 0 345 604 0105
Connectivity Functions
Conguring Network Settings
Your TV’s Network Settings include Wired
and Wireless Connection options. However,
if your TV does not have USB Wi-Fi dongle
(sold separately), you should use Wired
Connection type. If you try to connect via
Wireless Connection when your TV does not
have a USB Wi-Fi dongle, a warning screen will
appear and the TV will not get an IP address.
Try connecting the LAN cable after this and
then the TV will be able to get an IP address.
Conguring Wired Device Settings
If you are connecting the TV via ETHERNET
INPUT, select Network Type as Wired Device
to congure.
Network Type
Network type can be selected as Wired or
Wireless device, in accordance with the active
connection to the TV set. Select this as Wired if
you have connected to the TV a LAN cable. Select
as Wireless if you connect via the wireless USB
dongle (sold separately).
Conguration Status
This section displays the status of the connection.
Select Connected if you want to activate
connection. Select as Not Connected to end
an active connection.
IP Address
If an active connection is available, the IP address
will be displayed on this section. If you want to
congure IP address preferences, press GREEN
button and switch to the advanced mode.
Conguring Wired Network Settings in
Advanced Mode
After pressing GREEN button, Advanced mode
will be available. While in Advanced Mode, press
RED button to edit settings. When nished, press
OK to save, Press RETURN/BACK to cancel.
Configuring Wireless Device Settings (Optional)
IMPORTANT: “Veezy 200” USB dongle is required
to use wireless network feature. To use your TV
with your wireless network, you need a “Veezy 200”
Wireless USB dongle.
Wi-Fi feature can be used for a wireless network
connection. The feature is used for infrastructure
purposes only, such as connecting to the web,
hbb sites and connecting with DLNA servers
(optional). If you have the Veezy 200 Wifi
Dongle (sold separately), select Network Type
as Wireless Device to start connection process.
To enable Wi-Fi feature, profiles should be
congured properly. Please plug in the Wi-Fi dongle
(sold separately) to one of the USB ports.
Press YELLOW button to scan wireless network
from network settings menu. Afterwards,
available network list will be displayed. Please
select your desired network from the list.
If the selected network is protected with a
password, please enter the correct key by using
the virtual keyboard. You can use this keyboard
via navigation buttons (Left/Right/Up/Down)
and OK button on the remote control.
Wait until the IP the address is shown on the
screen.
42