94 4-1 Charging/Discharging Instructions
■ Specifications of equipment: 220V AC 50Hz 8A
■ Charging time: Please see the charging time prompt displayed on the
combination instrument or multimedia system.
Contact a BYD authorized service provider or a local electrician to select the
suitable power supply according to the requirements of charging equipment.
Grounding instructions for charging equipment: The equipment must be well
grounded. If the charging equipment becomes faulty or damaged, the
grounding wire will allow discharge in a circuit with the minimum impedance,
so that the risk of electric shock will be reduced. The charging equipment is
equipped with a grounding wire connecting the equipment grounding point and
the grounding point of power supply plug. The plug must match with the power
supply socket that is correctly installed and well grounded.
During charging, the charging connection cable should not be coiled;
otherwise, heat dissipation will be affected.
Refer to the charging instructions for specific charging precautions.
Refer to the charging safety warnings in the charging instructions for specific
charging safety warnings.
The maximum operating ambient temperature is 50°C. Please store this
product in a cool and dry place when it is not in use.
During charging, do not place the equipment in the trunk, under the vehicle
nose, or near the tire.
Do not drop or tread on the product or allow vehicle to run over it during use.
Do not let the equipment fall from height. Do not move the charging
equipment by directly pulling the cable. Handle it gently.
Do not modify, remove or repair the charging equipment or relevant ports.
It is not recommended to use any additional electric wire or adapter. If it is
necessary to add an external adapter, please select wire of appropriate
diameter (wire with diameter ≥1.5 m
2
) and the adapter parameters should
meet the requirements.
Do not use the charging equipment in the cases of softening of household
power supply plug-in wire, wearing of charging plug cable, cracking of
insulation layer, or any other damage conditions.
Do not use the charging equipment when the charging plug, power supply
plug or socket is broken, cracked or showing any surface damage conditions.
Do not continuously repeat the opening and closing of the charging port cap,
to prevent the cap failure.
To Next Page
