iNetVu™ Service Manual Page 92 of 109
4.13. Attaching Feed Arm to iNetVu™ 950 / 980 Reflector
This procedure describes the steps involved for installing the Feed Arm to the 0.95m /
0.98m Reflector on an iNetVu™ 950 / 980 Mobile Platform.
Required Materials:
7/16” Wrench
Procedure:
1. Locate feed arm bracket on the reflector.
2. Thread the screw through the feed arm bracket and feed arm as shown in the
figure below.
Fig. 53: Feed arm attached to feed arm bracket
3. Secure the feed arm by tightening the nut.
4. Congratulations! The feed arm has been successfully attached.
To Next Page
Loading...
