CAB 5314 Series - Mounting the Applicator

14 15
6 Installation
Fig.5 Mounting
1 Lay on the printer (1) on the rear side - print unit and material guiding on top.
2 Move the applicator (6) so in position to the printer that the holes in the mounting plate (4) are over the holes in
the base of the printer (1) .
3 Set on screws (5) and tighten it.
4 Connect SUB-D 15 male connector (3) to the female connector (2) of the printer.
!
Attention!
 Disconnect the printer from the power supply before mounting the applicator !
 Ensure a stable standing of the printer !
2
1
3
5
4
6
6.3 Mounting