CAB a2+ - Page 61

A2+/A4+/A6+/A8+
Memory cards
Edition 5/06 Configuration Instructions 61
8.4.3 Copy memory card
You can copy all the data from one memory card to another with the Copy memory card function.
Copying between memory cards with different memory capacities is possible. You can also use memory
cards which already contain data as a destination medium.
You can prevent unauthorized copying of memory cards by using a PIN. (see "Security" on Page 27)
1. Insert original card. (see "Insertion and removal" on Page 58)
2. Press the menu button.
3. Select Memory card > Copy memory card with the buttons X and W.
4. Press the ↵ button.
A selection field with the selection No appears in the display.
5. Use the S and T buttons to select Yes.
6. Press the ↵ button.
7. If the function Copy memory card is protected via a PIN, use the buttons S, T, X and W to enter
the code number and confirm with the ↵ button.
The copying procedure starts. When copying larger amounts of data, the copying procedure is carried
out in several copying cycles. An increasing progress indicator is shown in the display during a copy
cycle. The Insert dest. instruction then appears.
8. Remove original card and insert the card to be written to.
The data read from the original card is transferred to the copy card. The progress indicator in the dis-
play shrinks during this process. If only part of the data from the original card was read out, the
Insert source instruction appears.
9. Remove copy card and insert original card again.
The next copy cycle begins.
10.Repeat the previous two steps until all data has been copied.
OK is shown in the display when the entire copying procedure is complete.
11.Press the ↵ button.
If the card to be written to can no longer accept data during the copying procedure, the Card full error
message appears in the display.
CAUTION!
Data loss when copying.
If files with the same name are found on the original and copy cards, the files on the copy
card are overwritten without any prior notification. In addition, removal of the memory card
during the copying procedure leads to data loss.
⇒ Check files for the same name before copying.
⇒ Only remove or insert memory cards when so instructed in the display.