CAB a2+ - Interface Settings Management

18 Operating Instructions Edition 5/06
Loading media
A2+/A4+/A6+/A8+
6.1.4 Setting the label sensor
Fig. 6: Setting the label sensor
The label sensor (2) can be shifted perpendicular to the direction of paper flow for adaptation to the label
medium. The sensor unit (1) of the label sensor is visible from the front through the print unit and is
marked with a indentation in the label sensor retainer.
 Position label sensor with tab (3) in such a way that the sensor (1) can detect the label gap or a reflex
or perforation mark.
- or, if the labels deviate from a rectangular shape, -
 Align label sensor using the tab (3) with the front edge of the label in the direction of paper flow.
For use in Tear-Off mode only:
 Turn lever (Fig. 5, Item 9) clockwise to lock the printhead.
The label roll is loaded for use in Tear-Off mode.
1
2
3