CAB a2+ Operating Instructions

A2+/A4+/A6+/A8+
Loading media
Edition 5/06 Operating Instructions 19
6.1.5 Winding up the label strip in Rewind mode
Fig. 7: Guiding the label strip in Rewind mode
In Rewind mode, the labels are wound up internally after printing for later use.
1. Remove the locking system for Rewind mode if necessary (see ”6.7” on page 25) and install rewind
guide plate (see ”6.6” on page 24).
2. Guide label strip around the rewind guide plate (4) to the internal rewinder (2).
3. Hold rewinder (2) firmly and turn knob (3) clockwise until it stops.
4. Push label strip under a bracket (1) of the rewinder and turn knob (3) counterclockwise until it stops.
The rewinder is fully spread, thus gripping the label strip firmly.
5. Turn rewinder (2) counterclockwise to tighten the label strip.
6. Turn lever (5) clockwise to lock the printhead.
The label roll is loaded for use in Rewind mode.
2 13
5
4

CAB a2+ Specifications

General

Brand	CAB
Model	a2+
Category	Label Maker
Language	English