A2+/A4+/A6+/A8+
Device types
Edition 5/06 Operating Instructions 15
5 Device types
5.1 Standard device
The standard device is used for printing labels or continuous media on rolls or fanfolded media.
In Tear-Off mode, labels are removed by hand.
The labels can be cut off automatically with the 'cutter' accessory. For details, see the Operating Instruc-
tions for the 'cutter' accessory.
The labels can be wound up with the 'external rewinder' accessory. For details, see the Operating
Instructions for the 'external rewinder' accessory.
Because there is no internal rewinder, automatic peeling off of the labels from the carrier medium (Peel-
Off mode) and internal rewinding are not possible.
5.2 Peel-off device version
The peel-off device version is capable of Peel-Off mode and thus has an internal rewinder and a pulling
system comprised of a rewind assist roller and a locking system. Printing on labels or continuous media
from rolls or fanfolded media is possible.
Operation in Tear-Off mode and with the 'cutter' or 'external rewinder' accessory is possible by installing
the tear-off plate (see ”6.6” on page 24), as with the standard device.
In Peel-Off mode, the label is peeled off the liner after printing. The label can be removed by hand with
the peel-off sensor (accessory). Label removal can also occur automatically via the applicator (acces-
sory). The liner is rolled up via the internal rewinder.
For use in Internal Rewind mode remove the locking system (see ”6.7” on page 25) and replace the
dispense plate with a rewind guide plate (see ”6.6” on page 24).
To Next Page
Loading...
Need help?
General
