User’s Guide — 11
Changing Units of Measurement
The DigiRoller
™
Plus II can display and convert between the following
units of measure:
■ Feet-Inch
■ Decimal Feet
■ Inches
■ Yards
■ Meters
■ Acres (for displaying area values only)
You select your preferred unit of measure with the [Units] key.
Each press will advance through the above unit settings.
Any measurement on the display can be converted to the desired unit of
measure by pressing the [Units] key. For example, if the display shows:
and you would rather see the value displayed in inches, press the
[Units] key. You will see:
You can select different units of measurement for each measure conven-
tion (linear, square, cubic) just by pressing the [Units] key while display-
ing any linear, square or cubic value. The units of measurement you
choose will remain as they were last displayed until you change them
(even if you turn off the DigiRoller
™
Plus II).
To Next Page
Loading...
Need help?
General
