User’s Guide — 13
TAKING MEASUREMENTS
“Rolling” a Measurement
Here’s how to take a measurement with the DigiRoller
™
Plus II:
1. Turn the unit On by pressing the [On/Off] key. If the display
does not show zero (0), press the [Reset] key to clear the dis-
play.
2. Begin walking while rolling the DigiRoller
™
Plus II. You will see
the display registering your measurements.
Note: If you move the handle up or down while you are using
the unit, you will add or subtract a small distance (zero inches
to four inches) to any roll. For this reason, it is important to try
to keep the unit in the same position throughout the roll.
To Next Page
Loading...
Need help?
General
