16 — DigiRoller
™
Plus II
Deleting Stored Measurements
To permanently delete a stored value, press the delete key [DEL] and
then the key that has the value you want to delete. Be careful when
pressing the [DEL] key, as it will permanently erase the stored value
of the next key pressed.
If you accidentally press the [DEL] key, press [RESET] to prevent any
stored value from being erased.
Using the Counter
The DigiRoller
™
Plus II has a manual “count” function that allows you
to count various items you may be tracking as you roll your measure-
ment (for example, parking spaces, fire hydrants, etc.).
When you want to count something, press the [Count] key. If the bell
is on, the unit will beep each time it is pressed and the count total in
the upper left corner of the display will increase by one. To subtract
a count, press the [Set] key then the [Count] key.
To Next Page
Loading...
Need help?
General
