EasyManuals Logo

Calculated Industries 6425 User Manual

Calculated Industries 6425
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
42 — DigiRoller
Plus II
Error Codes
When an error occurs, the display will show one of the following mes-
sages:
Error 1 Attempt to enter a wheel ratio of 0%
Error 2
Attempt to add values of unlike dimensions in memory
Error 3 Attempt to move a current room with 0 length, 0
width, and non-zero height into the area key
nonE Attempt to enter fixed distance or AutoCount mode
with zero (0) stored in the fixed distance key
Lo batt Low battery power
FULL Attempt to move measurement(s) into the Area
Number registers but all Area Number registers are full
OFLO Attempt to display a value too large for display
Most errors can be cleared by pressing the [RESET] key.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Calculated Industries 6425 and is the answer not in the manual?

Calculated Industries 6425 Specifications

General IconGeneral
BrandCalculated Industries
Model6425
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals