Calculated Industries ElectriCalc Pro - Kirchhoffs Law Applications

20 — electricalc
®
Pro
Memory is semi-permanent, clearing only when you do one of
the following:
– turn off the calculator
– press 
– press 
– press  (Clear All).
When memory is recalled (
 ), consecutive presses of
 will display the calculated Average and total Count of the
accumulated values.
Using M+
KEYSTROKE DISPLAY
 (M+) M+ 355. &
 (M+) M+ 255. &
 (M+) M+ –745. &
 TTL – 135. &
  AVG – 45. &
  CNT 3. &
 – 135.
Using Memory Storage Keys (M1- M9)
In addition to the standard cumulative Memory (as previously
described), your calculator has nine independent Storage
Registers – M1 through M9 – that can be used to permanently
store single, non-cumulative values. The following example
shows the use of M1 ( ). To use M2 through M9, replace
the presses of the  key with presses of the corresponding
number key ( through 
) .
You can replace a value in one of these Memory registers by
storing a new value in place of the stored value.
(cont’d)