Calculated Industries ElectriCalc Pro - Appendix B - Preference Settings

56 — electricalc
®
Pro
APPENDIX B – PREFERENCE SETTINGS
The ElectriCalc Pro has Preference Settings that allow you to set
calculator modes. If you replace your batteries or perform a Full
Reset* (press  , hold down  , and press  ), your calculator
will return to the following settings (in addition to those listed on the
previous page), with the default setting for each preference listed
rst:
* Depressing the Reset button located above the  key will also
perform a Full Reset.
PREFERENCE OPTIONS
1) NEC Code – 2011: Sets the calculator to 2011 NEC
Code Year
– 2008: Sets the calculator to 2008 NEC
Code Year
– 2005: Sets the calculator to 2005 NEC
Code Year
– 2002: Sets the calculator to 2002 NEC
Code Year
– 1999: Sets the calculator to 1999 NEC
Code Year
– 1996: Sets the calculator to 1996 NEC
Code Year
2) Ambient
Temperature
Units
– °C: Ambient Temperature is stored and
displayed as °C.
– °F: Ambient Temperature is stored and
displayed as °F.
3) Length Units
– FEET: Length values stored or calculated
using the  key are displayed as Feet.
– METERS: Length values stored or calculated
using the  key are displayed as
Meters.