Calculated Industries ElectriCalc Pro - Default and Preference Settings

User's GUide — 55
APPENDIX A — DEFAULT SETTINGS
After a Clear All ( ), your calculator will return to the following
settings:
STORED VALUES DEFAULT VALUE
Insulation Rating 60º C
Wire Type Rating Copper
Phase 3Ø
Ambient Temperature 30º C (86º F)
Volts 240V
Voltage Drop % 3%
Power Factor % 100%
Efciency % 100%
Motor Type Induction
Conduit Type EMT
Fuse/Breaker Motor Type Squirrel Cage non Design E
Overload FLC% 115%
Free Air Mode* Off
* This setting will also return to its default upon turning the calculator off
and back on.
If you replace your batteries or perform a Full Reset* (Press  ,
hold down  and press  ) your calculator will return to the
following settings (in addition to those listed above):
PREFERENCE SETTINGS DEFAULT VALUE
NEC Code 2011
Ambient Tempurature Units °C
Length Units FEET
* Depressing the Reset button located above the  key will also
perform a Full Reset.