Calculated Industries ElectriCalc Pro User Manual

User's GUide — 59
auTO ShuT-OFF
Your calculator is designed to shut itself off after about 8-12
minutes of non-use.
baTTERY
The ElectriCalc Pro uses one CR2016 battery. Should your
calculator display become dim or erratic, replace the battery.
NOTE: Please use caution when disposing of your old battery as it
contains hazardous chemicals.
Replacement batteries are available at most discount or
electronics stores. You may also call Calculated Industries at
1-775-885-4900 or go to www.calculated.com.
Battery Replacement Instructions
While the calculator is off, turn the calculator over and use a
#1 Phillips screwdriver to remove the battery holder screw located
near the center at the top. With the screw removed, pull battery
holder out, remove old battery, and slide new battery into holder.
The negative side of the battery should be facing you as you insert
the battery holder into the calculator. Replace screw using a
#1 Phillips screwdriver.
RESET
If your calculator should ever “lock up,” press Reset — a small hole
located below the  key — to perform a total reset.

Calculated Industries ElectriCalc Pro Specifications

General

Type	Scientific
Cover	Yes
Form factor	Pocket
Control type	Buttons
Product color	Yellow
Digits	8 digits
Display type	LCD
Display tilting	No
Display size (HxV)	15.88 x 63.5 mm
Display number of lines	- lines
Display size (HxV) (imperial)	0.625 x 2.5 \
Storage media type	-
Battery type	CR2016
Power source	Battery
Battery voltage	3 V
Number of batteries supported	1

Weight and Dimensions

Depth	16 mm
Width	76 mm
Height	142 mm
Weight	127.5 g