CAME VER10 - Programming the partial opening; Programming the slow start with door open

CL.SENS.
Z
L56A
OP.SENS.
MOTOR FUSE
8A-F
2
1
ON
C
. FUSE 3,15A-F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS
CL.SENS.
OP.SENS.
O
R FUSE
F
2
1
ON
A
-F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS
CL.SENS.
OP.SENS.
O
R FUSE
F
2
1
ON
A
-F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS
 
CL.SENS.
OP.SENS.
E
2
1
ON
OPEN
OP / CL
AF
6
V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS

CL.SENS.
OP.SENS.
R FUSE
2
1
ON
-
F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS

p.
18
18 - Manual
FA00045-EN
FA00045-EN v.
2
2 - 09/2016 - © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice.
Press the ENC/RADIO button ❹ to memorize the closing point.
Press the OPEN button until the door reaches its completely-open point .
Press the ENC/RADIO button to memorize the opening point .
Reset DIP-switch 1 to OFF .
 Use the OP/CL button to command an opening and a closing to check that the programming was properly done.