CAME VER10 - Programming the closing slow-down

#,3%.3
/03%.3


/.
/0%.
/0#,
!&
-.

%
%.#2!$)/
!#4
3,/73%.3
#,3%.3
/03%.3


/.
/0%.
/0#,
!&

%
%.#2!$)/
!#4
3,/73%.3
CL.SENS.
ZL56A
OP.SENS.
MOTOR FUSE
8A-F
2
1
ON
ACC. FUSE 3,15A-F
N
E FUSE
1
,6A-F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS
#,3%.3
/03%.3
/0%.
/0#,
!&
%.#2!$)/
!#4
/03%.3
/0%.
/0#,
!&
%.#2!$)/
#,3%.3
/03%.3
/0%.
/0#,
!&
%.#2!$)/
!#4
#,3%.3
/03%.3


/.
/0%.
/0#,
!&
-
.

%
%.#2!$)/
!#4
3,/73%.3


p.
19
19 - Manual
FA00045-EN
FA00045-EN v.
2
2 - 09/2016- © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice.
Programming the partial opening
When the door is fully closed, set DIP-switch 2 to ON, the LED will fl ash .
Press the OPEN button until the door reaches the wanted opening position .
Press ENC/RADIO to memorize the partial opening .
Reset DIP-switch 2 to OFF .
Programming the slow start with door open (max. 50% of the door travel)
 Before programming, deactivate the automatic closing by setting the trimmer to
a minimum.
When the door is fully open, press the ENC/RADIO button, the LED will fl ash rapidly .
Set DIP-switch 1 to ON, the LED turns o .
Release the ENC/RADIO button, the LED fl ashes slowly .